Guide · 5 min read · Updated November 22, 2026
How Much Snow Is an Inch of Rain? Snow Ratios Explained
Short answer
The common rule is that 1 inch of rain equals about 10 inches of snow (a 10:1 ratio), but real snow varies a lot. Wet snow near freezing can be 5:1 to 8:1, while cold, fluffy snow can reach 20:1 or even 30:1, so the same storm can bring 5 or 30 inches depending on temperature.
Key takeaways
- 10:1 is a starting assumption, not a law: 1 inch of liquid can mean anywhere from about 5 to 30 inches of snow.
- Snow near the freezing point is wet and dense; snow falling through cold air is light and stacks up fast.
- Wind breaks snowflakes and packs them, which lowers the ratio.
- Open-Meteo's snowfall figures assume roughly 7 cm of snow per 1 cm of water, so treat them as an estimate.
"An inch of rain is ten inches of snow" is one of those numbers everyone repeats. It's a decent starting point, and also the reason so many snow forecasts end up looking wrong. The real answer depends on how cold the air is, how the flakes formed and how windy it gets.
What is the snow-to-liquid ratio?
The snow-to-liquid ratio compares the depth of fresh snow with the depth of water you'd get by melting it; 10:1 means 10 inches of snow melts down to 1 inch of water.
Weather models forecast precipitation as liquid water, in millimeters or inches. To turn that into a snow depth, forecasters multiply by a ratio. Ten is the classic choice because it fits snow falling around 28 to 34 °F (−2 to 1 °C), which is common in many winter storms.
Snow observers measure it directly: they collect fresh snow in a gauge, melt it and compare the water with the snow depth on a flat board.
Why does the ratio vary so much?
Temperature controls the shape of the snowflakes, and shape controls how much air ends up packed between them.
Branching, star-shaped crystals form best in cold clouds. They trap a lot of air and pile up into deep, light snow. Near freezing, flakes partly melt, stick together and fall as heavy clumps that pack down tightly.
| Conditions | Typical ratio | 1 inch of liquid gives |
|---|---|---|
| Near freezing, wet snow | 5:1 to 8:1 | 5 to 8 inches |
| Around 28 to 34 °F | About 10:1 | About 10 inches |
| Colder, around 10 to 20 °F | 15:1 to 20:1 | 15 to 20 inches |
| Very cold, dry powder | Up to about 30:1 | Up to about 30 inches |
Wind matters too. Strong wind breaks flakes into small pieces that pack together, so a windy storm usually produces lower ratios than a calm one at the same temperature. Climate plays a part as well: NOAA research notes that storm tracks across the US South tend to give lower ratios than fast, cold "clipper" systems further north.
How should you read a snowfall forecast?
Look at the precipitation amount and the temperature together, and treat the snow depth as a range rather than a single number.
- Find the liquid amount. If the forecast says 15 mm of precipitation, that's the water.
- Check the temperature during the snowfall. Near freezing, expect less depth; well below, expect more.
- Watch for mixing. If the forecast hovers around 32 °F (0 °C), some of the water may arrive as sleet or rain and never become snow at all.
- Read the wording. Phrases such as "3 to 6 inches" already include the forecaster's uncertainty about the ratio.
Open-Meteo, the open data source behind tmrw.is, reports snowfall in centimeters per hour and notes that 7 cm of snow corresponds to about 10 mm of water. That's a fixed conversion, so on very cold days real snow can be deeper than the number suggests, and on wet days shallower.
Why does wet snow matter more than deep snow?
Wet, low-ratio snow is much heavier per inch, so it causes more damage and is harder to shovel.
A foot of snow at 5:1 contains about 2.4 inches of water. A foot at 10:1 contains 1.2 inches. Half the depth of wet snow can weigh as much as a full foot of average snow. That weight is what snaps branches, pulls down power lines and strains flat roofs. For shoveling, it's the difference between pushing powder and lifting slush.
When you post about a coming storm, the type of snow is often more useful than the depth. "Heavy, wet snow" tells people to clear it early and watch the trees; "light, fluffy snow" tells them the roads may drift.
How can you post about snow without overpromising?
Give a range, say what kind of snow it is, and link to your national weather service for warnings.
- "Tomorrow: 2 to 5 cm of wet snow in the morning, turning to rain by noon."
- "Cold and dry tonight, so the 10 mm of precipitation could become 15 cm of powder. Drifting likely in open areas."
- "Snow totals depend on a degree or two. If temperatures stay above freezing, expect mostly slush."
For event days, the event rain check shows the hour-by-hour precipitation chance and amount for a time window, which helps you see whether a wintry spell lands before or after your start time. During a winter storm warning, our guide to sharing severe weather responsibly covers what to include and what to leave out.
In short
- 10:1 is a convenient average, not a rule.
- Colder means deeper and lighter; near freezing means shallower and heavier.
- Wind lowers the ratio.
- Read snow depth forecasts as ranges and always check the temperature beside them.
Questions and answers
Is 1 inch of rain always 10 inches of snow?
No. It's a rule of thumb for snow forming at roughly 28 to 34 °F. Warmer, wetter snow packs closer to 5:1 to 8:1, and very cold, dry snow can reach 20:1 or more.
How much snow does 10 mm of rain make?
At the 10:1 rule, about 10 cm. Real totals could be closer to 5 to 8 cm for heavy wet snow or 20 cm and more for light powder.
Why does a forecast's snow total change when the temperature forecast changes?
Because the ratio depends on temperature. A forecast that shifts a few degrees colder can turn the same amount of precipitation into deeper, fluffier snow, and a warmer shift can turn some of it into sleet or rain.
Why does heavy wet snow break branches?
Wet snow holds much more water per inch. A foot of wet snow at 5:1 weighs roughly twice as much as a foot of snow at 10:1, which is why it brings down branches and power lines.